Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK › from 2021.07
RM3700E _58 Vehicle Interior _093747 DOOR LOCK _0445092 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B621265N01
0.271,3.406 1.25,4.167 0.979,0.76 0.104,3.167 1.417,4.75 1.313,1.583 0.75,2.917 1,2.917 false 3.802,3.823 3.469,3.823 false 2.333,1.667 2.333,1.917 false 3.5,2.052 3.5,2.385 false 1.417,1.417 1.417,1.75 false 6.906,0.167 6.594,0.167 false 6.865,0.5 6.552,0.5 false 0.625,4.167 0.625,4.417 false 0.708,3.708 0.708,3.958 false 1.031,3.552 1.031,3.802 false 1,2.813 1.281,3.167 0.281,0.354 18 false 4 1.552,4.146 1.833,4.5 0.281,0.354 10 false x3 3.885,3.698 4.167,4.052 0.281,0.354 18 false 5 3.448,2.406 3.729,2.76 0.281,0.354 18 false 7 2.385,1.927 2.667,2.281 0.281,0.354 18 false 6 1.354,1.75 1.635,2.104 0.281,0.354 18 false 8 6.427,0.031 6.708,0.385 0.281,0.354 18 false 1 6.365,0.333 6.646,0.688 0.281,0.354 18 false 2 0.677,4.469 0.948,4.771 0.271,0.302 18 false 3 0.635,3.979 0.917,4.333 0.281,0.354 10 false *1 0.969,3.833 1.25,4.188 0.281,0.354 10 false *2 0.146,3.198 0.427,3.552 0.281,0.354 12 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY 69260E - - -
4 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL - - - -
5 REAR DOOR TRIM BOARD SUB-ASSEMBLY 67604 (Click here) - -
6 REAR DOOR GLASS INNER WEATHERSTRIP 68174A (Click here) - -
7 REAR DOOR BELT FRONT SEAL 68197A - - -
8 REAR DOOR BELT REAR SEAL 68199 - - -

*A w/o Power Window - -
*1 SHAFT SNAP RING *2 WINDOW REGULATOR HANDLE PLATE

B621266N01
3.594,0.583 3.927,0.583 false 1.719,0.583 2.052,0.583 false 2.563,2.5 2.896,2.5 false 3.573,4.698 3.906,4.698 false 1.667,2.75 1.667,3.083 false 4.521,3.542 4.417,3.01 4.417,3.01 4.25,3.01 false 1.813,4.406 2.188,4.406 false 0.885,5.469 1.115,5.583 1.115,5.583 1.281,5.583 false 1.635,5.021 1.938,5.167 1.938,5.167 2.104,5.167 false 1.802,3.917 2.052,3.917 false 3.375,4.521 3.656,4.875 0.281,0.354 18 false 9 3.271,0.448 3.552,0.802 0.281,0.354 18 false 10 1.635,3.135 2.063,3.49 0.427,0.354 18 false 11 1.448,0.417 1.875,0.771 0.427,0.354 18 false 12 2.281,2.333 2.708,2.688 0.427,0.354 18 false 13 2.344,5.063 2.771,5.417 0.427,0.354 18 false 14 1.635,5.438 2.063,5.792 0.427,0.354 18 false 15 1.052,3.729 1.979,4 0.927,0.271 18 false , 17 1.021,4.229 1.781,4.5 0.76,0.271 18 false , 19 0.594,4.771 0.906,4.969 0.313,0.198 10 false x3 3.167,2.708 3.479,2.906 0.313,0.198 10 false x2 2.531,1.396 2.844,1.594 0.313,0.198 10 false x2 0.927,2.99 1.24,3.188 0.313,0.198 10 false x2 3.979,2.917 4.333,3.115 0.354,0.198 10 false ● *1 0.771,3.813 1.198,4.167 0.427,0.354 12 false (*A) 0.49,3.729 1.417,4 0.927,0.271 18 false 16 0.76,4.313 1.188,4.667 0.427,0.354 12 false (*A) 1.49,3.813 1.917,4.167 0.427,0.354 12 false (*B) 1.479,4.313 1.906,4.667 0.427,0.354 12 false (*B) 0.5,4.229 1.26,4.5 0.76,0.271 18 false 18 1.563,5.49 1.708,5.688 0.146,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

9 REAR DOOR SERVICE HOLE COVER 67842E (Click here) - -
10 REAR DOOR GLASS RUN 68152C - - -
11 REAR DOOR GLASS SUB-ASSEMBLY 68104 (Click here) - -
12 REAR DOOR QUARTER WINDOW GLASS SUB-ASSEMBLY 68012 - - -
13 REAR DOOR WINDOW GUIDE PLATE LOWER 67447C - - -
14 REAR DOOR LOCK ASSEMBLY 69060A (Click here) - -
15 DOOR LOCK WIRING HARNESS SEAL 69318C (Click here) - -
16 REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY 69730M (Click here) - -
17 REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY 69730M (Click here) - -
18 REAR DOOR INSIDE LOCKING CABLE ASSEMBLY 69780B (Click here) - -
19 REAR DOOR INSIDE LOCKING CABLE ASSEMBLY 49780B (Click here) - -

*A w/o Double Locking System *B w/ Double Locking System
*1 BUTYL TAPE - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear door lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system (for Gasoline Model) Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the adove procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the power switch is turned to on (IG), the servo motor standard position is recognized. -


·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 69260E 3.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Z101186

Click here(Click here)

Hide 4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Hide 67604 5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 68174A 6.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

Z101186

Click here(Click here)

Hide 68197A 7.REMOVE REAR DOOR BELT FRONT SEAL

Hide 68199 8.REMOVE REAR DOOR BELT REAR SEAL

Hide 67842E 9.REMOVE REAR DOOR SERVICE HOLE COVER

Z101186

Click here(Click here)

Hide 68152C 10.REMOVE REAR DOOR GLASS RUN

Hide 68104 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 68012 12.REMOVE REAR DOOR QUARTER WINDOW GLASS SUB-ASSEMBLY

Hide 67447C 13.REMOVE REAR DOOR WINDOW GUIDE PLATE LOWER

Hide 69060A 14.REMOVE REAR DOOR LOCK ASSEMBLY

a.
B621267N01
2.365,0.844 2.51,1.125 0.146,0.281 18 true i 1.042,1.052 1.188,1.333 0.146,0.281 18 true ii 6.479,1.073 6.688,1.354 0.208,0.281 18 true iii

i.

Disconnect the connector.


ii.

Using a T30 "TORX" socket wrench, remove the 3 screws and rear door lock assembly.


iii.

Move the rear door lock assembly downward as shown in the illustration to disconnect it from the release plate of the rear door outside handle frame sub-assembly, and remove the rear door lock assembly.



Hide 69318C 15.REMOVE DOOR LOCK WIRING HARNESS SEAL

Z101186

When reusing the front door lock assembly:
Remove the door lock wiring harness seal from the front door lock assembly.

a.
B572310


Hide 69730M 16.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

a.
B621268C01
0.375,0.031 0.531,0.292 0.156,0.26 18 false i 4.073,0.021 4.302,0.365 0.229,0.344 18 false ii
V113147

Remove in this Direction - -


i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


ii.

Disengage the guide to remove the rear door lock remote control cable assembly from the rear door lock assembly.



Hide 69730M 17.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

a.
B621269N01
0.375,0.031 0.656,0.385 0.281,0.354 18 false i 4.01,0.031 4.292,0.385 0.281,0.354 18 false ii

i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


ii.

Disengage the guide to remove the rear door lock remote control cable assembly from the rear door lock assembly.



Hide 69780E 18.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

a.
B621270C01
0.417,0.031 0.552,0.292 0.135,0.26 18 false i 3.76,0.021 3.958,0.323 0.198,0.302 18 false ii
V113147

Remove in this Direction - -


i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


ii.

Disengage the guide to remove the rear door inside locking cable assembly from the rear door lock assembly.



Hide 69780E 19.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)

a.
B621271N01
0.417,0.031 0.552,0.292 0.135,0.26 18 false i 3.76,0.021 3.958,0.323 0.198,0.302 18 false ii

i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


ii.

Disengage the guide to remove the rear door inside locking cable assembly from the rear door lock assembly.