This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U032251 | Software Incompatibility with Body Control Module Not Programmed | Destination information of the main body ECU and blind spot monitor sensor do not match | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH (B) |
Blind Spot Monitor "B" | B |
| U032257 | Software Incompatibility with Body Control Module Invalid/Incompatible Software Component | Destination information of the main body ECU and blind spot monitor sensor do not match | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH (B) |
Blind Spot Monitor "B" | B |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U032251 | Software Incompatibility with Body Control Module Not Programmed | Destination information of the main body ECU and blind spot monitor sensor do not match | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor RH (A) |
Blind Spot Monitor "A" | B |
| U032257 | Software Incompatibility with Body Control Module Invalid/Incompatible Software Component | Destination information of the main body ECU and blind spot monitor sensor do not match | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor RH (A) |
Blind Spot Monitor "A" | B |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Before replacing the main body ECU (multiplex network body ECU), refer to the Service Bulletin.
Check the main body ECU (multiplex network body ECU) part number.
Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.
The part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| U032251 or U032257 is output | B |
| None of the above conditions are met | C |
A
B
C
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| U032251 or U032257 is output | B |
| None of the above conditions are met | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL