INITIALIZATION
If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).
Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>U340E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).
Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
USING INTELLIGENT TESTER
Read the intelligent tester instruction books before using the tester.
Make sure that the tester cable is not caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
When driving the vehicle for testing purposes while using the tester, 2 persons are required. One person drives the vehicle and the other operates the tester.