INITIALIZATION
If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).
Perform Registration (VIN registration) when replacing the ECM (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>REGISTRATION).
Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>U340E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).
Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
WHEN USING GTS
Before using the GTS read the instruction manual.
Make sure that the GTS cable is not caught on the pedals, shift lever and steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes while using the GTS, 2 persons are required. One person drives the vehicle, the other operates the GTS.