Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › 1NZ-FE SFI SYSTEM
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248039 1NZ-FE SFI SYSTEM D

1NZ-FE ENGINE CONTROL  1NZ-FE SFI SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

2.

Switch the ECM from normal mode to check mode using the tester (See page Engine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>CHECK MODE PROCEDURE).

3.

Perform a simulation test.

4.

Check and wiggle the harness(es), connector(s) and terminal(s).