Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248046 CAMSHAFT POSITION SENSOR A

1NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11101E 1.INSTALL CAMSHAFT POSITION SENSOR

a.
A095434E22
1.271,0.271 1.375,0.271 1.375,0.271 1.583,0.719 false 1.094,0.177 1.26,0.333 0.167,0.156 10 false *1

Apply a light coat of engine oil to the O-ring.

Text in Illustration
*1 O-ring

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:
·

Do not twist the O-ring.

·

If a component has been dropped or subjected to a strong impact, replace it.




c.

Connect the camshaft position sensor connector.


Hide 17705 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 28800 3.INSTALL BATTERY

a.

Install the battery.


b.

Install the battery clamp with the 2 nuts.

Torque:
3.5 N*m (36 kgf*cm, 31 in.*lbf)


Hide 5.INSPECT FOR ENGINE OIL LEAK