Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248048 IGNITION COIL AND SPARK PLUG A

1NZ-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


PROCEDURE

Hide 19500D 2.REMOVE NO. 1 IGNITION COIL

a.
A156073

Disconnect the 4 No. 1 ignition coil connectors.


b.
A156074

Remove the 4 bolts and the 4 No. 1 ignition coils.


Hide 3.REMOVE PLUG CAP

HINT:

If the plug cap has any damage, replace it with a new one.


a.

Remove the plug cap of the No. 1 ignition coil.

U134209E02
2.313,0.958 3.135,2.198 false 1.406,3.073 1.406,2.813 false 3.771,3.292 3.51,3.021 false 2.729,0.177 3.135,0.542 false 1.344,3.094 1.688,3.302 0.344,0.208 10 false *3 2.552,0.021 2.844,0.25 0.292,0.229 10 false *1 2.115,0.792 2.365,1.01 0.25,0.219 10 false *a 3.823,3.229 4.531,3.448 0.708,0.219 10 false *2

Text in Illustration
*1 No. 1 Ignition Coil *2 Plug Cap
*3 Spring - -
*a Plug Cap Fitting - -
V100135

Section A - -

NOTICE:
·

When removing the plug cap, make sure not to damage the plug cap fitting of the No. 1 ignition coil.

·

When removing the plug cap, do not deform the spring of the No. 1 ignition coil or allow it to fall out.

·

If the plug cap fitting has any damage, replace the No. 1 ignition coil with a new one.

·

If the spring is deformed or falls out, replace the No. 1 ignition coil with a new one. (The spring cannot be reassembled.)



HINT:

Spread section A of the plug cap and pull downwards to remove the plug cap.



Hide 19100P 4.REMOVE SPARK PLUG

a.
A156075

Using a 16 mm spark plug wrench, remove the 4 spark plugs.