Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › KNOCK SENSOR › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248050 KNOCK SENSOR A

1NZ-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

a.
A172936E07
1.863,1.937 2.103,2.097 0.239,0.159 10 30° 1.84,2.025 1.751,2.025 1.751,2.025 1.751,1.662 false

Install the knock sensor onto the cylinder block with the nut as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Make sure that the knock sensor is in the correct position.


·

If a component has been dropped or subjected to a strong impact, replace it.



NOTICE:

Make sure that the knock sensor is in the correct position.



b.

Connect the knock sensor connector.