When the engine is cranked, the ST (Starter) relay drive signal is input to the STA terminal of the ECM, and NE signal generated by the crankshaft position sensor is also input to the NE+ terminal. Thus, the ECM interprets that the engine has been cranked, and turns the transistor Tr1 in the ECM internal circuit ON. The current flows to the C/OPN (Circuit Opening) relay by turning the Tr1 ON. Then, the fuel pump operates. While the NE signal is input to the ECM with the engine running, the ECM turns the Tr1 on continuously.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel pump/Speed.
Check whether the fuel pump operating sound occurs when performing the Active Test on the tester.
| Result | Proceed to |
|---|---|
| Fuel pump operating sound does not occur | A |
| Fuel pump operating sound occurs | B |
A
B
Inspect the No. 1 integration relay (C/OPN relay) (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>INTEGRATION RELAY>INSPECTION).
OK
NG
Remove the No. 1 integration relay from the engine room relay block.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1E-11 - A74-7 (FC) | Always | Below 1 Ω |
| 1E-11 or A74-7 (FC) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the No. 1 integration relay from the engine room relay block.
Disconnect the fuel pump connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1E-5 - K17-4 | Always | Below 1 Ω |
| K17-5 - Body ground | Always | Below 1 Ω |
| 1E-5 or K17-4 - Body ground | Always | 10 kΩ or higher |
OK
NG
Inspect the fuel pump (See page Engine / Hybrid System>2NZ-FE FUEL>FUEL PUMP>INSPECTION).
OK
NG
Connect the intelligent tester to the DLC3.
turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the value displayed on the tester when the ignition switch is turned to ON and START.
| Ignition Switch Position | Starter Signal |
|---|---|
| ON | OFF |
| START | ON |
OK
NG
Connect the intelligent tester to the DLC3.
turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Engine Speed.
Read the values displayed on the tester while cranking.
Values are displayed continuously.
OK
NG