Be sure that the ignition is off if you work near the electric cooling fans or radiator grille. With the ignition on, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on.
1.DRAIN COOLANT
2.REMOVE HEADLIGHT ASSEMBLY
53630
3.SEPARATE HOOD LOCK CONTROL CABLE ASSEMBLY
Disengage the 2 clamps and separate the hood lock cable assembly.
Separate the hood lock control cable assembly from the hood lock.
53205
4.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
Disconnect the hood lock courtesy switch connector and disengage the wire harness clamp.
Separate the horn assembly connector.
Remove the 4 bolts and the upper radiator support sub-assembly.
5.DISCONNECT RADIATOR RESERVOIR TANK HOSE
Disconnect the radiator reservoir tank hose from the water filler.
16573B
6.REMOVE NO. 3 RADIATOR HOSE
Loosen the 2 clips and remove No. 3 radiator hose.
16572D
7.DISCONNECT NO. 2 RADIATOR HOSE
Loosen the clip and disconnect No. 2 radiator hose.
8.REMOVE INLET OIL COOLER HOSE (for Automatic Transaxle)
9.REMOVE OUTLET OIL COOLER HOSE (for Automatic Transaxle)
17700
10.REMOVE AIR CLEANER ASSEMBLY
16400
11.REMOVE RADIATOR ASSEMBLY
Separate the cooling fan motor connector and wire harness clamp.
Disengage the 2 claws and remove the radiator assembly from the vehicle.
Do not apply excessive force to the cooler condenser assembly or piping when removing the radiator assembly.
16572D
12.REMOVE NO. 2 RADIATOR HOSE
Loosen the clip and remove the No. 2 radiator hose.
16711
13.REMOVE FAN SHROUD
Disengage the 2 claws and remove the fan shroud.
16523A
14.REMOVE RADIATOR SUPPORT CUSHION
Remove the 2 radiator support cushions from the radiator assembly.
16470E
15.REMOVE GROMMET
Remove the 2 grommets from the radiator assembly.
16.REMOVE RADIATOR DRAIN COCK
Remove the radiator drain cock from the radiator assembly.