Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2014.07–2016.09
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248153 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control indicator light turns on.

CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE CONTROL INDICATOR LIGHT)
a.

Using the intelligent tester, perform the Active Test (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator light OFF/ON Vehicle is stopped and engine is idling

OK:

Indicator light turns on/off.




OK

2.READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL INDICATOR LIGHT)

NG

2.READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL INDICATOR LIGHT)
a.

Using the intelligent tester, read the Data List (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Indicator M-CPU Cruise control indicator (Main CPU) / OFF or ON OFF: Cruise control indicator light off
ON: Cruise control indicator light on
-

OK:

The display is as specified in the normal condition column.


Result
Result Proceed to
OK A
NG (for 2NZ-FE) B
NG (for 1NZ-FE) C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

C