Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248155 CLUTCH SWITCH A

CRUISE CONTROL  CLUTCH SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432B 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

a.

for LHD:

i.
B284274

Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



b.

for RHD:

i.
B272572

Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



Hide 73900 5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 84520E 6.REMOVE NO. 2 CLUTCH START SWITCH ASSEMBLY

a.

Disconnect the connector.


b.
C242413

Remove the nut and the No. 2 clutch start switch assembly.