Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
45287
3.REMOVE LOWER STEERING COLUMN COVER
Use the same procedure as for the LHD (See page Vehicle Exterior>WIPER / WASHER>WIPER SWITCH>REMOVAL).
55606
4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
73900
5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Remove the 4 bolts.
| *1 | Protective Tape |
| *2 | Locking Button |
Disengage the 6 claws to separate the lower No. 1 instrument panel airbag assembly.
Using a screwdriver with its tip wrapped in protective tape, release the locking button.
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.