This sensor detects the rotation speed of the input turbine. By comparing the input turbine speed signal (NT) with the speed sensor signal (SPD), the ECM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure in response to various conditions, thus performing smooth gear shifting.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0717 | All conditions below are detected for 5 seconds or more (1 trip detection logic).
(a) Gear change is not being performed. (b) Gear position: 3rd or 4th. (c) T/M input shaft rpm: Less than 300 rpm. (d) T/M output shaft rpm: 1000 rpm or more. (e) Park/neutral position switch (NSW, R and L) is OFF. (f) Shift solenoid valves, park/neutral position switch and vehicle speed sensor are in normal operation. |
·
Wire harness or connector ·
Transmission revolution sensor (Speed sensor NT) ·
Automatic transaxle (clutch, brake or gear etc.) ·
ECM |
The ECM detects the revolving signal from the transmission revolution sensor (input speed). The ECM outputs a gearshift signal by comparing the transmission revolution sensor signal with the speed sensor signal (SPD). While the vehicle is operating in the 3rd or 4th gear position in the shift position of D, if the input shaft speed is less than 300 rpm*1 although the output shaft speed is 1000 rpm*2 or more, the ECM detects the malfunction, illuminates the MIL and stores the DTC.
*1: Pulse is not output or is irregularly output.
*2: The vehicle speed is 50 km/h (31 mph) or more.
Check the transmission revolution sensor installation.
The installation bolt is tightened properly and there is no clearance between the sensor and transmission case.
| *a | Correct |
| *b | Incorrect |
| *c | Clearance |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ ABS) | B |
| NG (w/o ABS) | C |
A
B
C
Disconnect the transmission revolution sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (NT+) - 1 (NT-) | 20°C (68°F) | 560 to 680 Ω |
| *a | Component without harness connected
(Transmission Revolution Sensor) |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ ABS) | B |
| NG (w/o ABS) | C |
A
B
C
Connect the transmission revolution sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B84-125 (NT+) - B84-124 (NT-) | 20°C (68°F) | 560 to 680 Ω |
| B84-125 (NT+) - Body ground | Always | 10 kΩ or higher |
| B84-124 (NT-) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG