55606
1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55433D
2.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
55432B
3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL
83100
4.REMOVE COMBINATION METER ASSEMBLY
55107A
5.REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
Disconnect the connector and disengage the wire harness clamp.
Push the clutch master cylinder push rod clevis upward and release it toward the left side of the vehicle.
Remove the bolt, the 2 nuts and the clutch pedal support sub-assembly.
84520
6.REMOVE CLUTCH START SWITCH ASSEMBLY
Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.
31301F
7.REMOVE CLUTCH PEDAL STOPPER BOLT
Loosen the lock nut and remove the clutch pedal stopper bolt from the clutch pedal support sub-assembly.
31301A
8.REMOVE CLUTCH PEDAL SPRING
Remove the clutch pedal spring.
31301
9.REMOVE CLUTCH PEDAL SUB-ASSEMBLY
Remove the bolt, the nut and the clutch pedal sub-assembly from the clutch pedal support sub-assembly.
Turn the nut while holding the bolt.
31324A
10.REMOVE CLUTCH PEDAL SHAFT COLLAR
Remove the 2 clutch pedal bushes and the clutch pedal shaft collar from the clutch pedal sub-assembly.
31301B
11.REMOVE NO. 1 CLUTCH PEDAL CUSHION
Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
| *A | for 1NZ-FE |
| *B | for 2NZ-FE |
31321
12.REMOVE CLUTCH PEDAL PAD
Remove the clutch pedal pad from the clutch pedal sub-assembly.