Home › Drivetrain › CLUTCH › CLUTCH PEDAL(for RHD)
RM19S0E _52 Drivetrain _051467 CLUTCH _0248187 CLUTCH PEDAL(for RHD) A

CLUTCH  CLUTCH PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

HINT:

Use the same procedure as for LHD models (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL).


Hide 55432B 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

HINT:

Use the same procedure as for LHD models (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL).


Hide 55107A 4.REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY

a.

Disconnect the connectors and disengage the wire harness clamps.


b.
C235126

Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.


c.
C235127

Remove the 2 nuts and separate the clutch master cylinder assembly from the clutch pedal support sub-assembly.


d.
C235123

Remove the 2 bolts and the clutch pedal support sub-assembly.


Hide 84520 5.REMOVE CLUTCH START SWITCH ASSEMBLY

a.
C235128

Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.


Hide 84520E 6.REMOVE NO. 2 CLUTCH START SWITCH ASSEMBLY (w/ Cruise Control System)

a.
C242413

Remove the nut and the No. 2 clutch start switch assembly from the clutch pedal support sub-assembly.


Hide 31301F 7.REMOVE CLUTCH PEDAL STOPPER BOLT

a.
C235129

Loosen the lock nut and remove the clutch pedal stopper bolt from the clutch pedal support sub-assembly.


Hide 31301A 8.REMOVE CLUTCH PEDAL SPRING

a.
C242423

Remove the clutch pedal spring.


Hide 31301 9.REMOVE CLUTCH PEDAL SUB-ASSEMBLY

a.
C235130

Remove the bolt, the nut and the clutch pedal sub-assembly from the clutch pedal support sub-assembly.

NOTICE:

Turn the nut while holding the bolt.



Hide 31324A 10.REMOVE CLUTCH PEDAL SHAFT COLLAR

a.
C235131

Remove the 2 clutch pedal bushes and the clutch pedal shaft collar from the clutch pedal sub-assembly.


Hide 31453B 11.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH

a.
C235133

Using a hexagon wrench (8 mm) and a hammer, remove the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.


Hide 31301B 12.REMOVE NO. 1 CLUTCH PEDAL CUSHION

a.

Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.


Hide 31322 13.REMOVE CLUTCH PEDAL STOPPER

a.

Remove the clutch pedal stopper from the clutch pedal sub-assembly.


Hide 31321 14.REMOVE CLUTCH PEDAL PAD

a.

Remove the clutch pedal pad from the clutch pedal sub-assembly.