Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH
RM19S0E _52 Drivetrain _051467 CLUTCH _0248192 CLUTCH PEDAL SWITCH A

CLUTCH  CLUTCH PEDAL SWITCH  INSTALLATION  


PROCEDURE

Hide 84520E 1.INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY

a.

Install the No. 2 clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)


b.

Connect the No. 2 clutch start switch connector.


c.
C245183E01
2.111,2.263 2.280,2.424 0.170,0.161 10 *a

Without depressing the clutch pedal, check that the clearance shown in the illustration is as specified.

Text in Illustration
*a Clearance

Standard clearance:
for 1NZ-FE:

0.5 to 3.5 mm (0.020 to 0.138 in.)

for 2NZ-FE:

2.5 to 5.5 mm (0.098 to 0.217 in.)



Hide 84520 2.INSTALL CLUTCH START SWITCH ASSEMBLY

a.

Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)


b.

Connect the clutch start switch connector.


c.

With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.

C355408E01
0.448,0.271 0.76,0.469 0.313,0.198 10 false *A 4.521,0.281 4.833,0.479 0.313,0.198 10 false *B 1.01,3.208 1.323,3.406 0.313,0.198 10 false *a 4.917,3.219 5.229,3.417 0.313,0.198 10 false *a

Text in Illustration
*A for LHD *B for RHD
*a Clearance - -
V100135

Fully depressed - -

Standard clearance:
for LHD 1NZ-FE:

2.1 to 5.1 mm (0.083 to 0.201 in.)

for LHD 2NZ-FE:

2.0 to 5.0 mm (0.079 to 0.197 in.)

for RHD:

2.5 to 5.5 mm (0.098 to 0.217 in.)



Hide 55432B 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 73900 4.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55433D 5.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY