Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the airbag connector.
| *1 | Locking Button |
Push in the locking button.
Securely lock the locking button.
Engage the 6 claws and install the lower No. 1 instrument panel airbag assembly.
Install the 4 bolts.
55606
2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
45287
3.INSTALL LOWER STEERING COLUMN COVER
Use the same procedure as for the LHD (See page Vehicle Exterior>WIPER / WASHER>WIPER SWITCH>INSTALLATION).
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.INSPECT SRS WARNING LIGHT