58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE
57533B
3.REMOVE FRONT FLOOR CENTER BRACE (w/ Side Mudguard)
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY
17451
5.REMOVE EXHAUST PIPE GASKET
17451A
6.REMOVE NO. 2 EXHAUST PIPE GASKET
58151
7.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 2 bolts, nut and the front No. 1 floor heat insulator.
33820B
8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the clip A, and disconnect the control select cable from the floor shift shift lever assembly.
| *1 | Control Select Cable |
| *2 | Control Shift Cable |
| *3 | Clip A |
| *4 | Clip B |
| *5 | Nut |
| *6 | Shift Lever Plate |
| *a | Rotate 180° |
Disengage the clip B, and disconnect the control shift cable from the floor shift shift lever assembly.
Rotate the nut clockwise approximately 180° and, while holding the nut in that position, separate the control select cable from the shift lever plate.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
Rotate the nut clockwise approximately 180° and, while holding the nut in that position, separate the control shift cable from the shift lever plate.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
33820B
9.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the clip A and washer, and separate the control shift cable from the manual transaxle assembly.
| *1 | Control Shift Cable |
| *2 | Control Select Cable |
| *3 | Clip A |
| *4 | Clip B |
Remove the clip B from the control shift cable, and separate the control shift cable from the control cable bracket.
Remove the clip A and washer, and separate the control select cable from the manual transaxle assembly.
Remove the clip B from the control select cable, and separate the control select cable from the control cable bracket.
Remove the 3 nuts and the transmission control cable assembly.