Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › THROTTLE BODY
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0248042 THROTTLE BODY A

1NZ-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 17705 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

a.
A249575

Disconnect the fuel vapor feed hose from the vacuum switching valve assembly and air cleaner hose.


b.

Loosen the 2 hose clamps and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and vacuum switching valve assembly.


c.
A249576

Disconnect the No. 2 fuel vapor feed hose from the intake manifold.


d.
A249577

Disengage the 2 clamps and disconnect the wire harness from the air cleaner cap sub-assembly and vacuum switching valve assembly.


e.

Disconnect the mass air flow meter connector.


f.

Disconnect the vacuum switching valve connector.


g.
A249578

Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle with motor body assembly.


h.

Disengage the 2 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.


Hide 22030 4.REMOVE THROTTLE BODY ASSEMBLY

a.
A249579

Remove the 2 nuts and separate the water filter bracket from the throttle body assembly.


b.
A249580

Disconnect the No. 2 water by-pass hose from the throttle body assembly.


c.
A249581

Disconnect the water by-pass hose from the throttle body assembly.


d.
A249582

Disconnect the throttle body assembly connector.


e.

Disengage the wire harness clamp and separate the wire harness from the wire harness bracket.


f.
A249583

Remove the nut and wire harness bracket.


g.
A249584

Remove the bolt, 3 nuts and the throttle body assembly.


h.

Remove the gasket from the intake manifold.