Use the same procedure for the RH side as for the LH side.
The procedure listed below is for the LH side.
85110
1.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
55815E
2.REMOVE FRONT NO. 1 VENTILATOR SEAL
55735D
3.REMOVE FRONT AIR SHUTTER SEAL RH
55722C
4.REMOVE INNER COWL TOP TO COWL BRACE
55711
5.REMOVE OUTER COWL TOP PANEL
6.REMOVE FRONT WHEEL
48810
7.SEPARATE FRONT STABILIZER LINK ASSEMBLY
Remove the nut and separate the front stabilizer link assembly from the shock absorber.
Using a socket hexagon wrench 6 to hold the stud.
47313A
8.SEPARATE FRONT FLEXIBLE HOSE (w/ ABS)
Remove the bolt and separate the front speed sensor and front flexible hose.
47313A
9.SEPARATE FRONT FLEXIBLE HOSE (w/o ABS)
Remove the bolt and separate the front flexible hose.
48684B
10.REMOVE FRONT SUSPENSION SUPPORT DUST COVER
48520
11.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
Remove the 2 nuts and 2 bolts and separate the front shock absorber with coil spring from the steering knuckle.
Keep the bolt from rotating while loosening and removing the nuts.
Using a socket hexagon wrench 6, fix the front shock absorber rod and remove the nut.
Remove the front No. 2 suspension support.
Remove the front shock absorber with coil spring from the vehicle.
48609
12.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
48471C
13.REMOVE FRONT COIL SPRING UPPER SEAT
Using a socket hexagon wrench 6, fix the shock absorber rod and loosen the nut.
Using SST, compress the front coil spring.
Do not use an impact wrench. It will damage SST.
Remove the nut.
Remove the front coil spring upper seat with the strut mounting bearing and front spring bumper from the front shock absorber.
48331C
14.REMOVE FRONT SPRING BUMPER
Remove the front spring bumper from the front coil spring upper seat.
48157C
15.REMOVE FRONT COIL SPRING UPPER INSULATOR
48132
16.REMOVE FRONT COIL SPRING
48619A
17.REMOVE STRUT MOUNTING BEARING
Using a brass bar and press, remove the strut mounting bearing from the front coil spring upper seat.