Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD)
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248243 BRAKE BOOSTER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from booster by depressing the brake pedal several times.

Then remove the brake master cylinder from brake booster.


PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55433B 2.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

a.
B284273

Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.


Hide 55432B 3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL

a.

for LHD:

i.
B284274

Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



b.

for RHD:

i.
B272572

Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



Hide 85110 4.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

Hide 47201 5.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 47150 6.REMOVE PROPORTIONING VALVE ASSEMBLY (w/o ABS)

Hide 44510 7.REMOVE BRAKE ACTUATOR ASSEMBLY (w/ ABS)

Hide 55815E 8.REMOVE FRONT NO. 1 VENTILATOR SEAL

C242062

a.

Disengage the clamp and remove the front No. 1 ventilator seal.


Hide 55735D 9.REMOVE FRONT AIR SHUTTER SEAL RH

HINT:

Use the same procedure as for the No. 1 ventilator seal.


Hide 55722C 10.REMOVE INNER COWL TOP TO COWL BRACE

C242063

a.

Remove the 2 bolts and the inner cowl top to cowl brace.


Hide 55711 11.REMOVE OUTER COWL TOP PANEL

C242064

a.

Disengage the 2 clamps and separate the wire harness.


b.

Remove the 8 bolts and the outer cowl top panel.

C242065


Hide 47264D 12.SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

Hide 45260 13.SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

U134697E01
2.783,0.355 2.895,0.3 false 2.637,0.429 2.76,0.367 false 1.737,2.269 2.115,2.643 0.378,0.373 10 A 2.728,0.934 3.107,1.308 0.378,0.373 10 B 1.727,0.159 1.920,0.352 0.192,0.192 10 *a 2.849,0.323 1.921,0.267 1.921,0.267 2.706,0.394 false

a.

Place matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.

Text in Illustration
*a Matchmark


b.

Loosen bolt A.


c.

Remove bolt B and separate the No. 2 steering intermediate shaft assembly from the steering column assembly.


Hide 44610 14.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C244842

Slide the clip and disconnect the vacuum hose from the check valve.


b.
C241860

Remove the 4 nuts and brake booster assembly.

NOTICE:

Do not damage the brake tubes.



c.

Remove the gasket from the brake booster assembly.