Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER › 2011.08–2014.07
RM19S0E _53 Suspension _051473 REAR SUSPENSION _0248222 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48760B 1.INSTALL REAR SUSPENSION SUPPORT ASSEMBLY

Hide 48752A 2.INSTALL REAR SUSPENSION SUPPORT STOPPER

Hide 48540 3.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

a.

Support the rear axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.


b.

Jack up the rear axle beam slowly, and provisionally install the rear shock absorber assembly (lower side) with the bolt and nut onto the rear axle beam assembly.


c.

Install the suspension rear support and rear shock absorber cushion retainer.


d.
C106033

While holding the piston rod, install a new nut (lower nut) to the specified standard.

Standard:

15 to 18 mm (0.591 to 0.709 in.)



e.

Install a new nut (upper nut) onto the lower nut.


f.
U134679

Hold the lower nut and tighten the upper nut against it.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)


Hide 58732C 4.INSTALL REAR ABSORBER CAP

Hide 5.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 48540 7.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

a.

Fully tighten the rear shock absorber assembly (lower side) with the bolt.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)