Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2014.07–2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248226 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  ABS Warning Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

2.CHECK ABS WARNING LIGHT
a.

Disconnect the skid control ECU connector.


b.

Turn the ignition switch to ON.


c.

Check that the ABS warning light comes on.


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C

d.

Reconnect the skid control ECU connector.



A

3.READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT)

B

C