The circuit is used to send TRC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM or main body ECU (multiplex network body ECU) to the skid control ECU (brake actuator assembly) through the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1203 | Engine, drive source and destination variations that are sent from the ECM or main body ECU (multiplex network body ECU) do not match the ones of the skid control ECU (brake actuator assembly). | ·
ECM ·
Main body ECU (Multiplex network body ECU) ·
Skid control ECU (Brake actuator assembly) |
Check that the proper ECM is installed.
| Result | Proceed to |
|---|---|
| Proper ECM is installed | A |
| Proper ECM are not installed (for 1NZ-FE) | B |
| Proper ECM are not installed (for 2NZ-FE) | C |
A
B
C
Check that the proper main body ECU (multiplex network body ECU) is installed.
| Result | Proceed to |
|---|---|
| Proper ECU is installed | A |
| Proper ECU is not installed | B |
A
B
Check if the skid control ECU (brake actuator assembly) had been replaced before the DTC was recorded.
| Result | Proceed to |
|---|---|
| The brake actuator assembly is not replaced | A |
| The brake actuator assembly is replaced | B |
A
B
Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Perform initialization and calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>CALIBRATION).
NEXT
Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B