44546A
1.INSTALL BRAKE ACTUATOR BOLT CUSHION
Install the 3 brake actuator bolt cushions to the brake actuator bracket assembly.
Install the 3 brake actuator case collars to the brake actuator bolt cushion.
44590
2.INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY
Install the actuator bracket with the 3 bolts in the sequence shown in the illustration.
Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
Do not carry an actuator by its connector.
44510
3.INSTALL BRAKE ACTUATOR ASSEMBLY (w/o VSC)
Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
Do not damage the brake tubes or wire harness.
| *a | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Temporarily tighten each brake tube to the correct position on the brake actuator assembly as shown in the illustration.
Do not kink or damage the brake tubes.
Do not allow any foreign matter such as dirt or dust to enter the brake tubes from the connecting parts.
Using a union nut wrench 10 mm, connect the 6 brake tubes to the brake actuator assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the brake actuator connector.
| *1 | Lock Lever |
Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow entry of water, oil or dirt.
44510
4.INSTALL BRAKE ACTUATOR ASSEMBLY (w/ VSC)
Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
Do not damage the brake tubes or wire harness.
| *a | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Temporarily tighten each brake tube to the correct position on the brake actuator assembly as shown in the illustration.
Do not kink or damage the brake tubes.
Do not allow any foreign matter such as dirt or dust to enter the brake tubes from the connecting parts.
Using a union nut wrench 10 mm and union nut wrench 12 mm, connect the 6 brake tubes to the brake actuator assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the brake actuator connector.
| *1 | Lock Lever |
Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow entry of water, oil or dirt.
74411
5.INSTALL BATTERY CARRIER
74431
6.INSTALL BATTERY TRAY
28800
7.INSTALL BATTERY
8.BLEED BRAKE LINE
9.BLEED CLUTCH LINE (for Manual Transmission)
(See page Drivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING)
10.INSPECT ACTUATOR WITH INTELLIGENT TESTER
11. CHECK AND CLEAR DTC