In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.
Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.
If the power steering ECU assembly or steering column assembly has been replaced, perform the torque sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).
A
B
A
B
Turn the ignition switch off.
Disconnect the power steering ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F4-12 (TS) - F6-6 (TS) | Always | Below 1 Ω |
| F4-12 (TS) - Body ground | Always | 10 kΩ or higher |
Reconnect the power steering ECU connector.
OK
NG
OK
NG
Turn the ignition switch off.
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch to ON.
Check that the PS warning light is blinking.
| *a | Front view of DLC3 |
| Result | Proceed to |
|---|---|
| The PS warning light is not blinking | A |
| The PS warning light is blinking | B |
A
B