Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE
RM19S0E _54 Brake _051479 PARKING BRAKE _0248251 PARKING BRAKE CABLE A

PARKING BRAKE  PARKING BRAKE CABLE  INSTALLATION  


PROCEDURE

Hide 46430 1.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Install the No. 3 parking brake cable assembly onto the backing plate with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Install cable clamp B onto the rear axle beam.

NOTICE:

Securely install the clamp.


HINT:

When reusing the parking brake cable assembly, replace cable clamp B with a new part.



c.

Tighten the 5 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


d.

Pass the parking brake cable through a new cable clamp A, and then install cable clamp A onto the stud bolt.

NOTICE:

Securely install the clamp.



e.

Connect the No. 3 parking brake cable assembly onto the parking brake equalizer.


Hide 46420 2.INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 77606F 3.INSTALL FUEL TANK COVER VENT CASE SUB-ASSEMBLY

Hide 58153 4.INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR

Hide 04495 5.INSTALL REAR BRAKE SHOE KIT

Hide 42403 6.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 8.ADJUST PARKING BRAKE LEVER TRAVEL

Hide 58910C 9.INSTALL REAR CONSOLE BOX ASSEMBLY