Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.08–2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1515  Torque Sensor Zero Point Adjustment Undone  


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU assembly outputs this DTC when it determines that the torque sensor zero point calibration has not been performed.

DTC No. DTC Detection Condition Trouble Area
C1515 Torque sensor zero point calibration not performed.
·

Torque sensor zero point calibration not performing

·

Steering column assembly



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly, steering column assembly or power steering motor assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
a.

Perform torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



NEXT

2.CONFIRM DTC
2.CONFIRM DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is still output even after performing torque sensor zero point calibration 3 times*1. A
DTC is still output even after performing torque sensor zero point calibration once or twice*2. B
Normal system code is output. C

HINT:
·

*1: The power steering ECU assembly must be replaced if DTC C1515 is still output even after the torque sensor zero point calibration is performed 3 times.

·

*2: Perform the torque sensor zero point calibration again if DTC C1515 is still output even after the calibration is performed once or twice.





A

3.REPLACE POWER STEERING ECU ASSEMBLY

B

PERFORM ZERO POINT CALIBRATION AGAIN (TORQUE SENSOR)

C

END

3.REPLACE POWER STEERING ECU ASSEMBLY
a.

Replace the power steering ECU assembly.

HINT:




NEXT

4.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
4.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
a.

Perform the torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



NEXT

5.CONFIRM DTC
5.CONFIRM DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR ).

Result
Result Proceed to
DTC is still output even after performing torque sensor zero point calibration 3 times*1.
(for LHD)
A
DTC is still output even after performing torque sensor zero point calibration 3 times*1.
(for RHD)
B
DTC is still output even after performing torque sensor zero point calibration once or twice*2. C
Normal system code is output. D

HINT:
·

*1: The power steering ECU assembly must be replaced if DTC C1515 is still output even after the torque sensor zero point calibration is performed 3 times.

·

*2: Perform the torque sensor zero point calibration again if DTC C1515 is still output even after the calibration is performed once or twice.





A

REPLACE STEERING COLUMN ASSEMBLY

B

REPLACE STEERING COLUMN ASSEMBLY

C

PERFORM ZERO POINT CALIBRATION AGAIN (TORQUE SENSOR)

D

END