This DTC does not indicate a malfunction. The power steering ECU assembly outputs this DTC when it determines that the torque sensor zero point calibration has not been completed successfully.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1516 | Torque sensor zero point calibration not completed successfully. | ·
Torque sensor zero point calibration failure ·
Steering column assembly |
If the power steering ECU assembly, steering column assembly or power steering motor assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Clear the DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
NEXT
Perform torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION ).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is still output even after performing torque sensor zero point calibration 3 times*1. | A |
| DTC is still output even after performing torque sensor zero point calibration once or twice*2. | B |
| Normal system code is output. | C |
*1: The power steering ECU assembly must be replaced if DTC C1516 is still output even after the torque sensor zero point calibration is performed 3 times.
*2: Perform the torque sensor zero point calibration again if DTC C1516 is still output even after the calibration is performed once or twice.
A
B
C
Replace the power steering ECU assembly.
for LHD (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU(for LHD)>REMOVAL)
for RHD (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU(for RHD)>REMOVAL)
NEXT
Perform the torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is still output even after performing torque sensor zero point calibration 3 times*1.
(for LHD) |
A |
| DTC is still output even after performing torque sensor zero point calibration 3 times*1.
(for RHD) |
B |
| DTC is still output even after performing torque sensor zero point calibration once or twice*2. | C |
| Normal system code is output. | D |
*1: The power steering ECU assembly must be replaced if DTC C1516 is still output even after the torque sensor zero point calibration is performed 3 times.
*2: Perform the torque sensor zero point calibration again if DTC C1516 is still output even after the calibration is performed once or twice.
A
B
C
D