When an incorrect ECM is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1582 | Assist map number mismatch | ·
Power steering ECU assembly ·
CAN communication system ·
ECM |
If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
A
B
C
A
B
C
D