Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.08–2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1581  Assist Map Number Un-Writing  


DESCRIPTION

The power steering ECU assembly outputs this DTC when it determines that the assist map is not written in the ECU.

DTC No. DTC Detection Condition Trouble Area
C1581 Assist map not written in power steering ECU assembly
·

Power steering ECU assembly

·

CAN communication system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



PROCEDURE

1.PERFORM ASSIST MAP WRITING
a.


NEXT

2.CONFIRM DTC
2.CONFIRM DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1581 is not output.


HINT:

DTC C1581 will be cleared after the assist map is written.




OK

END

NG

3.CHECK CAN COMMUNICATION SYSTEM
3.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs of the CAN communication system.

Yaw Rate Sensor Type See Page
except Separate Type Yaw Rate Sensor (Click here)
for Separate Type Yaw Rate Sensor (Click here)

Result
Result Proceed to
DTCs is not output A
DTCs is output (except Separate Type Yaw Rate Sensor) B
DTCs is output (for Separate Type Yaw Rate Sensor) C



A

4.CHECK ECM

B

C

4.CHECK ECM
a.

Check if an ECM that complies with the vehicle specifications is installed.

OK:

The ECM that complies with vehicle specifications is installed.


Result
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG (for 1NZ-FE) C
NG (for 2NZ-FE) D



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C

D