This DTC is stored when a malfunction occurs in the speakers.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C3 | A short is detected in the speaker output circuit. | ·
Harness or connector ·
Speakers ·
Radio and display receiver assembly |
Disconnect the F125 and F126 radio and display receiver assembly connectors.
Disconnect the F91 and F92 front No. 2 speaker assembly connectors.
Disconnect the I4 and J4 rear speaker assembly connectors.
Measure the resistance between the radio and display receiver assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F125-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| F125-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| F125-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| F125-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| F126-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| F126-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| F126-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| F126-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the G8 and H8 front No. 1 speaker assembly connectors.
Disconnect the F91 and F92 front No. 2 speaker assembly connectors.
Measure the resistance between each of the front No. 2 speaker assemblies and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F91-3 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F91-1 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F92-3 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F92-1 (TWL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL).
Inspect the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION).
OK
NG
Remove the rear speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Inspect the rear speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION).
OK
NG
Temporarily replace the front No. 2 speaker assembly with a new or normally functioning one (See page Audio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>REMOVAL).
Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR).
No DTCs are output.
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
OK
NG