This DTC is stored when a malfunction occurs in the "Bluetooth" antenna which is connected to the navigation receiver assembly.
The "Bluetooth" antenna is built into the navigation receiver assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B157E | "Bluetooth" antenna is not connected | ·
Navigation receiver assembly ·
Antenna cord sub-assembly (for "Bluetooth" / "Wi-Fi") |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
Replace the antenna cord sub-assembly (for "Bluetooth" / "Wi-Fi") with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG