The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is in the LOCK or ACC positions. The key reminder warning buzzer is activated when the main body ECU sends a key switch signal and driver side courtesy light switch signal to the combination meter.
Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with How to Proceed with Troubleshooting. Then conduct the following troubleshooting procedure.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| FL Door Courtesy | Front LH door courtesy light switch signal / ON or OFF | ON: Front LH door closed
OFF: Front LH door opened |
- |
When the unlock warning switch is operated, the display changes as shown in the table.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Key Unlock Warning SW | Unlock warning switch signal / OFF or ON | OFF: Ignition key is not inserted
ON: Ignition key is inserted |
- |
When the unlock warning switch is operated, the display changes as shown in the table.
OK
NG
Remove the key from the key cylinder, turn the light control switch on the headlight dimmer switch assembly to the tail position, and open the driver door.
The light reminder warning buzzer sounds.
The key reminder warning system sounds the buzzer built in to the combination meter for key reminder warnings. This buzzer is also used for the light reminder warning system. Therefore, check the operation of the combination meter buzzer by checking if the buzzer sounds to inform that the lights are still on.
OK
NG
Inspect the unlock warning switch assembly (See page Vehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>INSPECTION).
OK
NG
Disconnect the F15 unlock warning switch and F76 main body ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F15-1 - F76-17 (KSW) | Always | Below 1 Ω |
| F15-2 - Body ground | Always | Below 1 Ω |
| F15-1 - Body ground | Always | 10 kΩ or higher |
OK
NG