When a key is inserted into the ignition key cylinder, the transponder key coil receives the key ID code and sends it to the transponder key ECU assembly.
When replacing the key and transponder key ECU assembly, refer to the Service Bulletin.
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
| Result | Proceed to |
|---|---|
| No DTC output | A |
| DTC output | B |
A
B
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Stored as Freeze Frame Data |
|---|---|---|---|
| Immobiliser Fuel Cut | Status of immobiliser fuel cut/
ON or OFF |
- | Yes |
The item in the Data List indicates "OFF"
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for 1NZ-FE) | B |
| OK (for 2NZ-FE) | C |
A
B
(See pageEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
C
(See pageEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check that the theft warning indicator light turns off when a registered key is inserted into the ignition key cylinder.
Theft warning indicator light turns OFF.
OK
NG
Check that the theft warning indicator light turns off when another registered key is inserted into the ignition key cylinder.
Theft warning indicator light turns OFF.
OK
NG
Perform inspection using a different key that has been registered to the vehicle.
It leaves for 5 seconds by the ignition switch ON status, and the engine starting operation is done.
| Result | Proceed to |
|---|---|
| Engine cannot be started | A |
| Engine can be started | B |
A
(See pageEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Replace the transponder key coil (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL).
NEXT
Check that the engine starts with an already registered vehicle key.
Engine starts normally.
OK
NG
Replace the transponder key ECU assembly with a new one (Refer to Service Bulletin).
NEXT
Reregister the key (Refer to Service Bulletin).
NEXT
Register the ECU communication ID (Refer to Service Bulletin).
NEXT
Check that the engine starts with an already registered vehicle key.
Engine starts normally.
OK
NG
Replace the transponder key master transmitter with a new one (Refer to Service Bulletin).
NEXT
Reregister the key (Refer to Service Bulletin).
NEXT
Check that the engine starts with an already registered vehicle key.
Engine starts normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1NZ-FE) | B |
| NG (for 2NZ-FE) | C |
A
B
(See pageEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
C
(See pageEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)