Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY(for 3 Door)
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248321 CURTAIN SHIELD AIRBAG ASSEMBLY(for 3 Door) G

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY(for 3 Door)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 62170A 1.INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)


b.

With the curtain shield airbag installed on the vehicle, perform a visual check. If there are any defects, such as those mentioned below, replace the front pillar garnish or roof headlining with a new one:

·

Any cuts, minute cracks or marked discoloration on the front pillar garnish and roof headlining around the curtain shield airbag.


B282740


Hide 62170A 2.INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)

B282742

CAUTION:

For curtain shield airbag removal and installation procedures, see pages Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CURTAIN SHIELD AIRBAG ASSEMBLY(for 3 Door)>REMOVAL and Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CURTAIN SHIELD AIRBAG ASSEMBLY(for 3 Door)>INSTALLATION, and carefully follow the correct procedure.



b.

With the curtain shield airbag removed from the vehicle, if there are any defects, such as those mentioned below, replace the curtain shield airbag with a new one:

·

Any cuts, minute cracks or marked discoloration on the curtain shield airbag.

·

Any cracks or other damage to the connector.