Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
73210
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Check the angle of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15 ° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45 ° or more.
| *a | Unlock |
| *b | Lock |
Do not disassemble the retractor.
If the operation is not as specified, replace the front seat outer belt assembly.
Engage the 2 hooks and temporarily install the front seat outer belt assembly with the 2 bolts.
Tighten bolt A and then bolt B.
for bolt A
for bolt B
Connect the pretensioner connector.
| *1 | Locking Button |
Lock the locking button.
Securely lock the locking button.
Install the shoulder anchor part of the front seat outer belt assembly with the bolt.
Install the floor anchor part of the front seat outer belt assembly with the bolt.
Check that the ELR locks.
The check should be performed with the front seat outer belt installed.
With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the front seat outer belt.
Remove the bolt and the floor anchor.
62411B
2.INSTALL CENTER PILLAR UPPER GARNISH
62413A
3.INSTALL CENTER PILLAR LOWER GARNISH
73210
4.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Install the floor anchor part of the front seat outer belt assembly with the bolt.
Engage the 3 claws and install the lap belt outer anchor cover.
62331A
5.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
62311B
6.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
67917A
7.INSTALL REAR DOOR SCUFF PLATE
67913
8.INSTALL FRONT DOOR SCUFF PLATE
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10.INSPECT SRS WARNING LIGHT