The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
2.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
3.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
58410B
4.REMOVE DECK BOARD ASSEMBLY
64771G
5.REMOVE SPARE WHEEL COVER
81250
6.REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
09113
7.REMOVE JACK HANDLE (for RH Side)
58387B
8.REMOVE REAR FLOOR FINISH PLATE
67917A
9.REMOVE REAR DOOR SCUFF PLATE
62331A
10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
73360
11.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
64730B
12.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
64740C
13.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
62471A
14.REMOVE ROOF SIDE INNER GARNISH
73360
15.REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Remove the bolt and the shoulder anchor part of the rear seat 3 point type outer belt assembly.
Remove the bolt, disengage the 2 hooks to remove the rear seat 3 point type outer belt assembly.
73143
16.REMOVE SEAT BELT HOLE SEAL
Disengage the 2 claws to remove the seat belt hole seal.