In this circuit, the compressor with pulley assembly receives a refrigerant compression demand signal from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly changes the amount of compressor output.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1451/51 | An open or short in the cooler compressor solenoid circuit. | ·
Compressor with pulley assembly ·
Harness or connector ·
Air conditioning amplifier assembly |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Regulator Control Current | Regulator control current /
Min.: 0 A Max.: 0.997 A |
Value changes between 0.12 A and 0.997 A in accordance with compressor operation | - |
The display is as specified in the normal condition column.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
A
B
C
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
B1451/51 is not output
OK
NG
Inspect the compressor with pulley assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 1NZ-FE, 2NZ-FE)>INSPECTION).
OK
NG
Disconnect the B77 compressor with pulley assembly connector.
Disconnect the F42 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B77-2 (SOL+) - F42-2 (SOL+) | Always | Below 1 Ω |
| B77-2 (SOL+) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the B77 compressor with pulley assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B77-1 (SOL-) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Compressor with Pulley Assembly) |
OK
NG