When the No. 2 heater control sub-assembly (blower switch) is set to position 1 or higher, the contact of the heater blower motor relay assembly (HTR relay) relay is closed, current flows to the blower motor, and the blower motor operates. The blower motor speed can be changed by exchanging the ground and the blower resistor circuit with the No. 2 heater control sub-assembly (blower switch).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Inspect the heater blower motor relay assembly (HTR relay) (See page Vehicle Interior>HEATING / AIR CONDITIONING>RELAY>ON-VEHICLE INSPECTION).
OK
NG
Inspect the blower motor with fan sub-assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT BLOWER MOTOR>INSPECTION).
OK
NG
Remove the heater blower motor relay assembly (HTR relay).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| HTR-5 - Body ground | Always | 11 to 14 V |
| HTR-1 - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| HTR-4 - Body ground | Always | Below 1 Ω |
| *1 | Heater Blower Motor Relay Assembly (HTR Relay) Holder |
OK
NG
Remove the heater blower motor relay assembly (HTR relay).
Disconnect the F41 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| HTR-2 - F41-14 (HR) | Always | Below 1 Ω |
| HTR-2 - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the F39 No. 2 heater control sub-assembly (blower switch) connector.
Disconnect the F41 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F39-9 (LO) - F41-17 (SBLW) | Always | Below 1 Ω |
| F39-9 (LO) - Body ground | Always | 10 kΩ or higher |
OK
NG
w/ Fan Shroud Ventilation Duct
Disconnect the F96 blower motor with fan sub-assembly connector.
w/o Fan Shroud Ventilation Duct
Disconnect the F35 blower motor with fan sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F96-2 - Body ground | Ignition switch ON
Blower switch ON |
11 to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F35-2 - Body ground | Ignition switch ON
Blower switch ON |
11 to 14 V |
| *A | w/ Fan Shroud Ventilation Duct |
| *B | w/o Fan Shroud Ventilation Duct |
| *a | Front view of wire harness connector
(to Blower Motor with Fan Sub-Assembly) |
OK
NG
w/ Fan Shroud Ventilation Duct
Disconnect the F96 blower motor with fan sub-assembly connector.
w/o Fan Shroud Ventilation Duct
Disconnect the F35 blower motor with fan sub-assembly connector.
Disconnect the F34 blower resistor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F96-1 - F34-4 (HI) | Always | Below 1 Ω |
| F96-1 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F35-1 - F34-4 (HI) | Always | Below 1 Ω |
| F35-1 - Body ground | Always | 10 kΩ or higher |
OK
NG
Inspect the blower resistor (See page Vehicle Interior>HEATING / AIR CONDITIONING>BLOWER RESISTOR>INSPECTION).
OK
NG
Inspect the No. 2 heater control sub-assembly (blower switch) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Air Conditioning System)>INSPECTION).
OK
NG
Disconnect the F39 No. 2 heater control sub-assembly (blower switch) connector.
Disconnect the F34 blower resistor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F39-5 (E) - F34-1 (E) | Always | Below 1 Ω |
| F39-6 (M2) - F34-2 (M2) | Always | Below 1 Ω |
| F39-7 (M1) - F34-3 (M1) | Always | Below 1 Ω |
| F39-10 (HI) - F34-4 (HI) | Always | Below 1 Ω |
| F39-5 (E) - Body ground | Always | Below 1 Ω |
| F39-6 (M2) - Body ground | Always | 10 kΩ or higher |
| F39-7 (M1) - Body ground | Always | 10 kΩ or higher |
| F39-10 (HI) - Body ground | Always | 10 kΩ or higher |
OK
NG