Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248226 ANTI-LOCK BRAKE SYSTEM Y

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer and confirm the trouble.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC AND FREEZE FRAME DATA*
3.CHECK DTC AND FREEZE FRAME DATA*
a.

Check and record DTC and Freeze Frame Data.



c.

Reconfirm the DTC.

i.

Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR for DTC Check/Clear, or Click here Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>FREEZE FRAME DATA for Freeze Frame Data).

HINT:

If any of the DTCs U0100, U0123, U0124, U0126, and U0142 are output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CHECK FOR INTERMITTENT PROBLEMS




Result:
Result Proceed to
DTC is output A
DTC is not output (Problem symptom does not occur) B
DTC is not output (Problem symptom occurs) C



A

4.DIAGNOSTIC TROUBLE CODE CHART

B

5.SYMPTOM SIMULATION

C

6.PROBLEM SYMPTOMS TABLE
4.DIAGNOSTIC TROUBLE CODE CHART

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
5.SYMPTOM SIMULATION

Result:
Proceed to
NEXT



NEXT

6.PROBLEM SYMPTOMS TABLE
6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
7.CIRCUIT INSPECTION*
Result:
Proceed to
NEXT



NEXT

8.IDENTIFICATION OF PROBLEM
8.IDENTIFICATION OF PROBLEM
Result:
Proceed to
NEXT



NEXT

9.REPAIR OR REPLACEMENT
9.REPAIR OR REPLACEMENT
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST*
10.CONFIRMATION TEST*
Result:
Proceed to
NEXT



NEXT

END