Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM › 2014.07–2017.01
RM19S0E _58 Vehicle Interior _051490 DOOR LOCK _0248289 WIRELESS DOOR LOCK CONTROL SYSTEM Y

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system.

·

Use this procedure to troubleshoot the wireless door lock control system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Check the battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.


Result:
Proceed to
NEXT



NEXT

3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the intelligent tester to check if the CAN communication system is functioning normally.

HINT:



Result:
Result Proceed to
DTC is not output A
DTC is output (for Separate Type Yaw Rate Sensor) B
DTC is output (except Separate Type Yaw Rate Sensor) C



A

4.PROBLEM SYMPTOMS TABLE

B

C

4.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACE
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
HINT:

Register the recognition code when replacing the door control transmitter or the door control receiver.


Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END