Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2016.09
RM19S0E _51 Engine / Hybrid System _051448 1NZ-FE ENGINE CONTROL _0292834 AIR FUEL RATIO SENSOR A

1NZ-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A251200C06
2.24,0.969 2.708,0.313 false 2.667,0.135 3.042,0.333 0.375,0.198 10 false SST 1.281,1.396 1.563,1.583 0.281,0.188 10 false *a 2.021,1.792 2.302,1.979 0.281,0.188 10 true *b
*a Torque Wrench Fulcrum Length
*b SST Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)

·

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>INITIALIZATION




b.

Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.


c.

Connect the air fuel ratio sensor connector.


Hide 55722C 3.INSTALL INNER COWL TOP TO COWL BRACE

Hide 55735D 4.INSTALL FRONT AIR SHUTTER SEAL RH

Hide 55815E 5.INSTALL FRONT NO. 1 VENTILATOR SEAL

Hide 6.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 7.INSPECT FOR EXHAUST GAS LEAK

Hide 8.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>1NZ-FE SFI SYSTEM>INITIALIZATION