Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ECM › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248058 ECM A

2NZ-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55815E 2.REMOVE FRONT NO. 1 VENTILATOR SEAL

Hide 55735D 3.REMOVE FRONT AIR SHUTTER SEAL RH

Hide 55722C 4.REMOVE INNER COWL TOP TO COWL BRACE

Hide 55711 5.REMOVE OUTER COWL TOP PANEL

Hide 74431 7.REMOVE BATTERY TRAY

Hide 89661 9.REMOVE ECM

a.
A281595

Pull up the lever to loosen the lock and disconnect the 2 connectors from the ECM.

NOTICE:

If there are is any foreign matter such as mud or water on a connector, clean the connector.



b.
A281597

Remove the bolt and nut, then remove the ECM.


Hide 89667E 10.REMOVE NO. 1 ECM BRACKET

a.
A247276

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668 11.REMOVE NO. 2 ECM BRACKET

a.
A247277

Remove the 2 screws and No. 2 ECM bracket.