Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for RHD)
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248244 BRAKE BOOSTER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from booster by depressing the brake pedal several times.

Then remove the brake master cylinder from brake booster.


PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432B 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

a.

for LHD:

i.
B284274

Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



b.

for RHD:

i.
B272572

Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 85110 4.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

Hide 47201 5.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 55815E 6.REMOVE FRONT NO. 1 VENTILATOR SEAL

A249556

a.

Disengage the clamp and remove the front No. 1 ventilator seal.


Hide 55735D 7.REMOVE FRONT AIR SHUTTER SEAL RH

HINT:

Use the same procedure as for the No. 1 ventilator seal.


Hide 55722C 8.REMOVE INNER COWL TOP TO COWL BRACE

A249554

a.

Remove the 2 bolts and the inner cowl top to cowl brace.


Hide 55711 9.REMOVE OUTER COWL TOP PANEL

A249552

a.

Disengage the 2 clamps and separate the wire harness.


b.

Remove the 8 bolts and the outer cowl top panel.

A249553


Hide 47264D 10.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

C107594

a.

Remove the brake pedal return spring.


b.

Loosen the push rod clevis lock nut.


c.

Remove the clip and push rod pin and separate the push rod clevis from the brake pedal.


d.

Remove the push rod clevis and push rod lock nut from the brake booster assembly.


Hide 44610 11.REMOVE BRAKE BOOSTER ASSEMBLY

C235200

a.

Slide the clip and disconnect the vacuum hose from the vacuum check valve.


b.

Separate the wire harness clamp.


c.
C233664

Separate the wire harness clamp and 4 nuts and remove the brake booster assembly.

NOTICE:

Do not damage the brake tubes.



d.

Remove the gasket from the brake booster assembly.