Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ECM › from 2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248058 ECM A

2NZ-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket with the 2 screws.


Hide 89667E 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket with the 2 screws.


Hide 89661 3.INSTALL ECM

a.

Install the ECM with the bolt and nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.



b.
A281596

Pull down the lever to engage the lock and connect the 2 connectors to the ECM.

NOTICE:

Make sure that the levers are securely locked.



Hide 74431 5.INSTALL BATTERY TRAY

Hide 55722C 8.INSTALL INNER COWL TOP TO COWL BRACE

Hide 55735D 9.INSTALL FRONT AIR SHUTTER SEAL RH

Hide 55815E 10.INSTALL FRONT NO. 1 VENTILATOR SEAL

Hide 11.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY