Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
1.TURN FRONT WHEELS FACING STRAIGHT AHEAD
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45186
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
45130
5.REMOVE STEERING PAD
45100
6.REMOVE STEERING WHEEL ASSEMBLY
45287
7.REMOVE LOWER STEERING COLUMN COVER
45286B
8.REMOVE UPPER STEERING COLUMN COVER
84306
9.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (w/ VSC)
| *1 | Slider |
Disconnect the horn connector from the spiral cable with sensor sub-assembly.
Slide the slider and disconnect the airbag connector from the spiral cable with sensor sub-assembly.
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
Disconnect the steering sensor connector from the spiral cable with sensor sub-assembly.
Disengage the 3 claws and remove the spiral cable with sensor sub-assembly.
Do not replace the spiral cable with sensor sub-assembly when the ignition switch is ON and the battery cable is connected.
Do not rotate the spiral cable with sensor sub-assembly when the ignition switch is ON and the battery cable is connected.
Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
Do not remove the steering sensor from the spiral cable with sensor sub-assembly.
If there is a malfunction in the steering sensor, replace the spiral cable with sensor sub-assembly with steering sensor.
10.REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/o VSC)
| *1 | Slider |
Disconnect the horn connector from the spiral cable sub-assembly.
Slide the slider and disconnect the airbag connector from the spiral cable sub-assembly.
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable sub-assembly.
Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.
Do not rotate the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.