Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
82142A
1.INSTALL NO. 2 INSTRUMENT PANEL WIRE
Connect the airbag connector to the No. 2 instrument panel wire.
| *1 | Locking Button |
Push in the locking button.
Do not damage the airbag wire harness when connecting the airbag connector.
Securely lock the locking button.
73960A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Engage the 3 hooks B.
Engage the 3 hooks A to install the instrument panel passenger airbag assembly.
Install the 2 screws
Engage the 2 clamps.
55844
3.INSTALL NO. 2 HEATER TO REGISTER DUCT
55302A
4.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.INSPECT SRS WARNING LIGHT