DTC C1AA0 is output when an internal circuit malfunction in the pre-crash safety city sensor is detected.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AA0 | Pre-crash safety city sensor detects an internal malfunction. | Pre-crash safety city sensor |
When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If a pre-crash safety city sensor which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be stored.
If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Pre-crash Safety City Sensor Learning.
Adjustment (One time recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)
Adjustment (Sequential recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)
Check if the stored DTCs are current DTCs.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AA0 is output | A |
| DTC C1AA0 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Replace the pre-crash safety city sensor with a new one (See pageVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>REMOVAL).
Perform pre-crash safety city sensor beam axis learning.
Adjustment (One time recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)
Adjustment (Sequential recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)
NEXT